Pump Testing Centre
Pump Service Centre
Mectron pump centre is housed in our 1,404m² factory and is fully equipped with the necessary tools and fixtures to handle the overhauling of pumps in the correct procedure. Mectron provides complete overhaul and repair capabilities of pumping systems. Our services include:
- Scheduled Maintenance
- Pump Overhaul
- Pump Retrofit and Upgrade
- On-site Repair of Pumps
- Site Installation of Pumps
- Field Commissioning
- Performance Testing of Pumps
- Hydrostatic Testing
A pump performance test can also be ordered after the repair and overhaul of the pump unit.
Ensuring installed pumps are running in the optimal condition and in accordance with prescribed operation instructions to ensure a smooth and trouble-free operation. Our site team is technically trained and equipped with all the necessary diagnostic tools to provide the proper start-up and commissioning including condition monitoring. This includes:
- Pump and Driver Alignment
- Measure of flow rate
- Pressure Measurement
- Power Measurement
Diagnostic Instruments at disposal by on-site team:
- Pump Alignment Equipment
- Vibration Analyser Brüel & Kjær Pulse Lite 3560L FFT Analyser
- Power Analyser SKYLAB 9032 1kW to 1,000kW
- Non-Invasive Doppler Flowmeter AURORA DDF- 4M / R240
General Arrangement Drawing
The Metron engineering design is provided the proposed design drawing known as general arrangement drawing according to our customer’s requirements and standards, the general arrangement drawing include pump package and utilities arrangement, civil layout, construction drawing, piping and other equipment’s layout.
As-built drawing is provided based on final approval general arrangement drawing, construction drawing, and or based on after erection or installations in our customer site that shows all agreed changes, actual dimensions, tolerances, geometries, and equipment’s scope installed.
Mectron engineering also can produced shop drawing (includes calculation and selection of the supporting equipment) regards the customer needed and standards that are include fabrication drawing, machining drawing, material cutting plan, material take-off/ bill of material, etc.